Base Frame:
Base frame is made of pressed mild steel channel
The main structural element is of 100 mm x 50 mm 'C' channels and cross member is of 'C' channels section size 75 mm x 40 mm
Side and End Walls:
Side & end frames made out of pressed sections of suitable profiles/pillars of sufficient strength with exterior wall made up of 1.8 swg M.S specially corrugated sheets
9 mm particle board are used for interior walls where steel sheet are treated for corrosion resistance
Panels are vertically corrugated with sheets that are continuously welded to top side & base structures so as to offer better strength to weight ratio where all gaps are sealed at edges and at seams, bottom etc to prevent ingress of moisture
Flooring Systems:
On bottom frame 18 mm thick plywood, bison panel/E board is fixed by means of self taping screws and PVC vinyl flooring shall be fixed on the panels
Roof:
Self draining type roof is provided using 1.8 swg thick M.S. sheet with adequate roof bows
Roofs are adequately cambered for draining of rain water and interior panelling is done in 9 mm particle board with adequate insulation
Paint:
Epoxy Zinc Phosphate primer & synthetic Epoxy paint is used for final 2 coats
Corrosion free and fire proof paints
Insulation:
50 mm thick Rock wool insulation is used for walls & 50 mm thick Rock wool insulation is provided for roof
Aluminium Windows:
Aluminium sliding type powder coated windows provided that are made of aluminium section, 5 mm thick, tinted glasses are to be fitted to it
Electrical System:
Modular portable office cabin provided with electrical wiring suitable for 250 volt, 50 HZ single phase AC power supply
All electrical wiring are concealed where suitable copper cables are used for lighting circuits
The copper cables used are of 3/19 cable for lighting circuits
ISI mark & concealed PVC conduits insulated copper wire are used for wiring required to be done in PVC conduit with small size distribution board with MCB protection and to separate with main supply
